2000 Toyota Tundra Rear Axle Removal

They are located behind the rear brake drums.

2000 toyota tundra rear axle removal. The lines are directly above the axle. My problem was the axle seal kept failing and leaking oil which made the bearings fail because lack of lubrication. Last year I thought its was shoes and wheel cylinder replaced those but issues continued.

When a rear axle seal goes bad its typically noticeable by gear oil leaking all over a rear wheel and it may get into the brake drum and reduce rear brake feel. They cant seem to get the bearing and housing to bust loose from the axle. 14mm wrench Second remove the 2 brake lines from the drums.

It seems too difficult to find a clean assemblyhousing with that exact configuration but I see. The issues is it feels like every time I stop at a redlight stop sign or in general my driver side rear drum hangs up. Forums Tundra Discussion 1st Gen Tundras 2000-2006.

I went up there to check it out. Unfortunately for the truck I live in New England. Ive been looking for a replacement rear axle assembly or at least a rear axle housing for my 4x4 with ABS and an E-locker.

This will expose the parking brake cable end shown below. Discussion Starter 1 Dec 20 2011 Edited Took my 08 Tundra 2wd to a local shop that specializes in trucks so they can replace the rear axle bearing. Hello everyone Im the proud owner of an 03 Tacoma 4x4.

On AmazonREAR WHEEL BEARING KIT. I got a 2000 Toyota Tundra 47 Auto. Less common causes can be a bent axle housing or shaft.