2000 Toyota Tundra Ignition Switch Problems

Insert the vehicle key in the ignition.

2000 toyota tundra ignition switch problems. One problem related to ignition switch has been reported for the 2006 Toyota Tundra. The Tundras ignition lock cylinder itself can go bad over time. I got the code to reset the radio but don t know the procedure.

The most recently reported issues are listed below. The most recently reported issues are listed below. Put the graphite in then put the key in and out of the ignition several times without turning the key so as to distribute the graphite then try turning the key.

From what I can tell in the diagram pg 76-83 if youve already replaced the ignition switch its probably the ECM. The way it starts makes me think it is a bad connection or corroded wire. This is the lock pin.

The first is when the starter cranks but the bad ignition switch doesnt turn on the fuel pump or ignition. Toyota Key wont turn in Ignition The key wouldnt turn in my Toyota Corolla ignition and I used graphite. The key slides in and out easily but will not turn past the ACC setting.

Turn the key clockwise to the Run position. In the ACC position the radio or fan may be energized. I have a 2000 toyota tundra that will not engage when I turn the key.

Identify the HIGH MOUNT STOP LAMP circuit WITHOUT a Rear Spoiler. Sounds like you are having to cycle the key several time to get it to start and this has gradually gotten worse so the ignition switch might be an easy solution. I found out this was part of the anti theft system on the truck.